Bradford White Error 10: Air Supply or Exhaust Blockage
Documented in Bradford White Tankless Service Manual 238-45095-00 for the EverHot IGI-180R/IGI-180C interior tankless (the cited manual is correct; the 'Infiniti K-series / GR-GS combi condensing' platform attribution is inaccurate — the K-series uses alphanumeric codes). We diagnose and repair it across Greater Vancouver — same-day and after-hours.
Documented in Bradford White Tankless Service Manual 238-45095-00 for the EverHot IGI-180R/IGI-180C interior tankless (the cited manual is correct; the 'Infiniti K-series / GR-GS combi condensing' platform attribution is inaccurate — the K-series uses alphanumeric codes).
Bradford White fault codes can vary by model and series. Use this as a guide — the same code can have more than one cause. Our Technical Safety BC–licensed technicians read the code, confirm it against your unit's manual, and diagnose the true cause before any repair.
Likely causes of Bradford White error 10
- Blocked or improperly connected vent/flue components (inlet or exhaust)
- Wrong venting material or improperly installed condensation collar
- Obstruction or debris in the intake or exhaust terminal
- Incorrect dip-switch (vent length) settings
- Excessive vent length / too many elbows
What you can safely check
- Visually inspect the outdoor vent terminal for snow, leaves, nests or debris and clear anything blocking it
- Make sure nothing is stacked against or covering the unit's intake and exhaust
Beyond these checks, do not open the unit or touch gas/electrical parts — BC law requires a licensed gas fitter. Call us for a proper diagnosis.
Parts Are Professionally Installed — Not Sold for DIY
For your safety and to keep your manufacturer warranty valid, BoilerPart.ca does not sell loose boiler parts over the counter or for self-installation. Under BC regulations, gas appliance components must be installed by a licensed gas fitter. Every part we source is genuine OEM and is professionally fitted, tested, and certified by our Technical Safety BC–licensed technicians as part of a complete repair or installation.
Parts often behind Bradford White error 10
Genuine Bradford White parts we supply and professionally install — never for DIY.
Our Guarantees & Warranties
Every repair and installation is backed by genuine parts, licensed workmanship, and a promise to make it right.
Workmanship Guarantee
Every repair and installation is backed by our written workmanship guarantee. If a part we installed fails because of our work, we make it right.
Genuine OEM Parts
We fit only manufacturer-original (OEM) components so your boiler performs to spec and keeps its factory warranty intact.
Manufacturer Warranty Honoured
As an authorised service provider for the brands we work on, our installs preserve and register your manufacturer parts warranty.
Licensed & Insured
All work is completed by Technical Safety BC–licensed gas fitters (Licence LGA0043870, Boiler Permit LBP0046450). We are fully licensed, bonded and insured for your protection.
Up-Front Pricing
You approve the diagnosis and quote before any work begins. No hidden fees and no surprise charges.
Satisfaction Commitment
Backed by the full HVAC resources of CanroHeat.ca and four decades of service in Greater Vancouver since 1985.
Bradford White Error 10 Repair Across Metro Vancouver
Related Bradford White Venting & Combustion Codes
Frequently Asked Questions
Fix Bradford White Error 10 Today
Licensed Bradford White diagnosis and repair with genuine parts — same-day and after-hours across Greater Vancouver.
A Division of CanroHeat.ca · Licensed Gas Fitters · Serving Greater Vancouver since 1985