Camus Error Ignit Error: Ignition Error — Failed Trials
Manual-reset (hard lockout) code: three unsuccessful ignition attempts in a row. The DynaMax control will not re-fire until the RESET button is pressed. Documented in the DynaMax DMH081 Manual Reset Codes table (internal code 1). We diagnose and repair it across Greater Vancouver — same-day and after-hours.
Manual-reset (hard lockout) code: three unsuccessful ignition attempts in a row. The DynaMax control will not re-fire until the RESET button is pressed. Documented in the DynaMax DMH081 Manual Reset Codes table (internal code 1).
Camus fault codes can vary by model and series. Use this as a guide — the same code can have more than one cause. Our Technical Safety BC–licensed technicians read the code, confirm it against your unit's manual, and diagnose the true cause before any repair.
Likely causes of Camus error Ignit Error
- No gas or low gas supply pressure to the burner
- Failed hot surface igniter not reaching proof current
- Weak or contaminated flame sensor signal
- Gas valve or air/gas ratio out of adjustment
- Air in the gas line after service
What you can safely check
- Verify other gas appliances work (confirms gas supply)
- Make sure the manual gas valve to the boiler is open
Beyond these checks, do not open the unit or touch gas/electrical parts — BC law requires a licensed gas fitter. Call us for a proper diagnosis.
Error Ignit Error usually leaves you without heat or hot water and can indicate a safety-related fault. Don't keep resetting it — call for priority after-hours Camus repair.
Parts Are Professionally Installed — Not Sold for DIY
For your safety and to keep your manufacturer warranty valid, BoilerPart.ca does not sell loose boiler parts over the counter or for self-installation. Under BC regulations, gas appliance components must be installed by a licensed gas fitter. Every part we source is genuine OEM and is professionally fitted, tested, and certified by our Technical Safety BC–licensed technicians as part of a complete repair or installation.
Parts often behind Camus error Ignit Error
Genuine Camus parts we supply and professionally install — never for DIY.
Our Guarantees & Warranties
Every repair and installation is backed by genuine parts, licensed workmanship, and a promise to make it right.
Workmanship Guarantee
Every repair and installation is backed by our written workmanship guarantee. If a part we installed fails because of our work, we make it right.
Genuine OEM Parts
We fit only manufacturer-original (OEM) components so your boiler performs to spec and keeps its factory warranty intact.
Manufacturer Warranty Honoured
As an authorised service provider for the brands we work on, our installs preserve and register your manufacturer parts warranty.
Licensed & Insured
All work is completed by Technical Safety BC–licensed gas fitters (Licence LGA0043870, Boiler Permit LBP0046450). We are fully licensed, bonded and insured for your protection.
Up-Front Pricing
You approve the diagnosis and quote before any work begins. No hidden fees and no surprise charges.
Satisfaction Commitment
Backed by the full HVAC resources of CanroHeat.ca and four decades of service in Greater Vancouver since 1985.
Camus Error Ignit Error Repair Across Metro Vancouver
Frequently Asked Questions
Fix Camus Error Ignit Error Today
Licensed Camus diagnosis and repair with genuine parts — same-day and after-hours across Greater Vancouver.
A Division of CanroHeat.ca · Licensed Gas Fitters · Serving Greater Vancouver since 1985