Laars Error 92: Outlet Sensor Fault
The outlet (supply) water temperature sensor circuit is open or shorted, so the control cannot read supply temperature and holds/stops the burner. We diagnose and repair it across Greater Vancouver — same-day and after-hours.
The outlet (supply) water temperature sensor circuit is open or shorted, so the control cannot read supply temperature and holds/stops the burner.
Laars fault codes can vary by model and series. Use this as a guide — the same code can have more than one cause. Our Technical Safety BC–licensed technicians read the code, confirm it against your unit's manual, and diagnose the true cause before any repair.
Likely causes of Laars error 92
- Loose or corroded outlet sensor connector
- Damaged sensor wiring
- Failed outlet temperature sensor
- Faulty control module
What you can safely check
- Confirm the thermostat is calling for heat
- Check the boiler pressure gauge is in the normal range
Beyond these checks, do not open the unit or touch gas/electrical parts — BC law requires a licensed gas fitter. Call us for a proper diagnosis.
Error 92 usually leaves you without heat or hot water and can indicate a safety-related fault. Don't keep resetting it — call for priority after-hours Laars repair.
Parts Are Professionally Installed — Not Sold for DIY
For your safety and to keep your manufacturer warranty valid, BoilerPart.ca does not sell loose boiler parts over the counter or for self-installation. Under BC regulations, gas appliance components must be installed by a licensed gas fitter. Every part we source is genuine OEM and is professionally fitted, tested, and certified by our Technical Safety BC–licensed technicians as part of a complete repair or installation.
Parts often behind Laars error 92
Genuine Laars parts we supply and professionally install — never for DIY.
Our Guarantees & Warranties
Every repair and installation is backed by genuine parts, licensed workmanship, and a promise to make it right.
Workmanship Guarantee
Every repair and installation is backed by our written workmanship guarantee. If a part we installed fails because of our work, we make it right.
Genuine OEM Parts
We fit only manufacturer-original (OEM) components so your boiler performs to spec and keeps its factory warranty intact.
Manufacturer Warranty Honoured
As an authorised service provider for the brands we work on, our installs preserve and register your manufacturer parts warranty.
Licensed & Insured
All work is completed by Technical Safety BC–licensed gas fitters (Licence LGA0043870, Boiler Permit LBP0046450). We are fully licensed, bonded and insured for your protection.
Up-Front Pricing
You approve the diagnosis and quote before any work begins. No hidden fees and no surprise charges.
Satisfaction Commitment
Backed by the full HVAC resources of CanroHeat.ca and four decades of service in Greater Vancouver since 1985.
Laars Error 92 Repair Across Metro Vancouver
Related Laars Sensors & Temperature Codes
Frequently Asked Questions
Fix Laars Error 92 Today
Licensed Laars diagnosis and repair with genuine parts — same-day and after-hours across Greater Vancouver.
A Division of CanroHeat.ca · Licensed Gas Fitters · Serving Greater Vancouver since 1985