Slant/Fin Error Lockout 2: Waiting for safety data verification
The control is stuck waiting for safety-data verification. The documented cause is a faulty SOLA controller, and the corrective action is to replace the SOLA controller. We diagnose and repair it across Greater Vancouver — same-day and after-hours.
The control is stuck waiting for safety-data verification. The documented cause is a faulty SOLA controller, and the corrective action is to replace the SOLA controller.
Slant/Fin fault codes can vary by model and series. Use this as a guide — the same code can have more than one cause. Our Technical Safety BC–licensed technicians read the code, confirm it against your unit's manual, and diagnose the true cause before any repair.
Likely causes of Slant/Fin error Lockout 2
- Faulty SOLA controller
- Corrupted internal safety data
- Failed control self-verification on power-up
What you can safely check
- Try a single power-cycle reset of the boiler
- If the code persists, the control likely needs replacement — call a technician
Beyond these checks, do not open the unit or touch gas/electrical parts — BC law requires a licensed gas fitter. Call us for a proper diagnosis.
Error Lockout 2 usually leaves you without heat or hot water and can indicate a safety-related fault. Don't keep resetting it — call for priority after-hours Slant/Fin repair.
Parts Are Professionally Installed — Not Sold for DIY
For your safety and to keep your manufacturer warranty valid, BoilerPart.ca does not sell loose boiler parts over the counter or for self-installation. Under BC regulations, gas appliance components must be installed by a licensed gas fitter. Every part we source is genuine OEM and is professionally fitted, tested, and certified by our Technical Safety BC–licensed technicians as part of a complete repair or installation.
Parts often behind Slant/Fin error Lockout 2
Genuine Slant/Fin parts we supply and professionally install — never for DIY.
Our Guarantees & Warranties
Every repair and installation is backed by genuine parts, licensed workmanship, and a promise to make it right.
Workmanship Guarantee
Every repair and installation is backed by our written workmanship guarantee. If a part we installed fails because of our work, we make it right.
Genuine OEM Parts
We fit only manufacturer-original (OEM) components so your boiler performs to spec and keeps its factory warranty intact.
Manufacturer Warranty Honoured
As an authorised service provider for the brands we work on, our installs preserve and register your manufacturer parts warranty.
Licensed & Insured
All work is completed by Technical Safety BC–licensed gas fitters (Licence LGA0043870, Boiler Permit LBP0046450). We are fully licensed, bonded and insured for your protection.
Up-Front Pricing
You approve the diagnosis and quote before any work begins. No hidden fees and no surprise charges.
Satisfaction Commitment
Backed by the full HVAC resources of CanroHeat.ca and four decades of service in Greater Vancouver since 1985.
Slant/Fin Error Lockout 2 Repair Across Metro Vancouver
Frequently Asked Questions
Fix Slant/Fin Error Lockout 2 Today
Licensed Slant/Fin diagnosis and repair with genuine parts — same-day and after-hours across Greater Vancouver.
A Division of CanroHeat.ca · Licensed Gas Fitters · Serving Greater Vancouver since 1985