Can you replace the flame sensor on my Slant/Fin boiler?

Yes. We supply and professionally install the genuine part across Greater Vancouver. Our licensed technicians diagnose the fault, fit the correct OEM part, and test the system.

Do you sell the Slant/Fin flame sensor on its own?

No. Boiler parts are supplied and installed by our licensed technicians as part of a repair — we do not sell parts for individual or DIY purchase. We install the Slant/Fin flame sensor as part of a certified repair so it is fitted correctly, tested for safety, and keeps your Slant/Fin warranty valid.

How do I know my Slant/Fin flame sensor has failed?

Typical symptoms include: Boiler lights then shuts off; Repeated lockouts after ignition; E012 / flame-loss codes; Short-cycling on start-up. On Slant/Fin boilers this can also show as No Heat or Pilot Issues. We confirm the diagnosis before any work.

Slant/Fin · Ignition & Flame

Slant/Fin Flame Sensor Replacement in Greater Vancouver

Genuine Slant/Fin flame sensor, supplied and professionally installed by Technical Safety BC–licensed gas fitters. Never sold for DIY.

Call (604) 359-1081 Request Service

The Flame Sensor on Your Slant/Fin Boiler

The flame sensor (flame-rectification probe) confirms a flame is actually burning. If it cannot detect flame, the control shuts the gas off within seconds. A dirty or failed sensor causes the boiler to light then drop out repeatedly.

On Slant/Fin systems — including models such as Sentry, Galaxy, Victory VHS — a failing flame sensor often shows up as no heat or related symptoms. We diagnose it precisely and install the correct genuine Slant/Fin part.

Typical Lifespan

5-10 years

Brand

Slant/Fin

Part Category

Ignition & Flame

Safety Warning

A boiler that fires then locks out within seconds is the textbook symptom of a failing flame sensor.

Signs of a Failing Slant/Fin Flame Sensor

Boiler lights then shuts off

Repeated lockouts after ignition

E012 / flame-loss codes

Short-cycling on start-up

Parts Are Professionally Installed — Not Sold for DIY

For your safety and to keep your manufacturer warranty valid, BoilerPart.ca does not sell loose boiler parts over the counter or for self-installation. Under BC regulations, gas appliance components must be installed by a licensed gas fitter. Every part we source is genuine OEM and is professionally fitted, tested, and certified by our Technical Safety BC–licensed technicians as part of a complete repair or installation.