Boiler Relay / Switching Board Replacement in Greater Vancouver
Switches pumps and zones on multi-zone systems. Supplied and professionally installed by licensed gas fitters — never sold for DIY.
What the Relay / Switching Board Does
Relay and switching boards coordinate multiple circulators or zone valves and the boiler on multi-zone hydronic systems. A failed relay leaves a zone or pump that will not run, or runs constantly.
Thermostat calls energise relays that start the right pump or zone and signal the boiler to fire, sequencing a multi-zone system so each area gets heat on demand.
We supply and fit the relay / switching board as part of a complete boiler repair or new installation, and inspect it during annual maintenance for homes across Greater Vancouver.
Typical Lifespan
10-15 years
Category
Controls & Sensors
Service Priority
medium
Safety Warning
A pump that runs non-stop or a zone that never starts often points to a failed relay board.
Signs Your Relay / Switching Board Needs Attention
Noticing any of these in your Greater Vancouver home? Our technicians can diagnose it same-day.
Common causes of relay / switching board failure
- Worn relay contacts
- Board electronics failure
- Wiring fault
- Power surge
Parts Are Professionally Installed — Not Sold for DIY
For your safety and to keep your manufacturer warranty valid, BoilerPart.ca does not sell loose boiler parts over the counter or for self-installation. Under BC regulations, gas appliance components must be installed by a licensed gas fitter. Every part we source is genuine OEM and is professionally fitted, tested, and certified by our Technical Safety BC–licensed technicians as part of a complete repair or installation.
Relay / Switching Board for Every Major Boiler Brand
We supply and install genuine relay / switching boards for these brands across Greater Vancouver.
How We Replace Your Relay / Switching Board
Call & Diagnose
Describe the symptoms and we dispatch a licensed technician to confirm the relay / switching board fault.
Up-Front Quote
You approve the diagnosis and price before any work begins — no surprises.
Install Genuine Part
We fit the correct OEM relay / switching board to manufacturer spec.
Test & Certify
Full combustion, pressure and safety testing, backed by our workmanship guarantee.
Boiler Problems a Failing Relay / Switching Board Can Cause
Seeing one of these symptoms? A worn or failed relay / switching board is a common cause — we diagnose and repair it across Greater Vancouver.
Our Guarantees & Warranties
Every repair and installation is backed by genuine parts, licensed workmanship, and a promise to make it right.
Workmanship Guarantee
Every repair and installation is backed by our written workmanship guarantee. If a part we installed fails because of our work, we make it right.
Genuine OEM Parts
We fit only manufacturer-original (OEM) components so your boiler performs to spec and keeps its factory warranty intact.
Manufacturer Warranty Honoured
As an authorised service provider for the brands we work on, our installs preserve and register your manufacturer parts warranty.
Licensed & Insured
All work is completed by Technical Safety BC–licensed gas fitters. We are fully licensed, bonded and insured for your protection.
Up-Front Pricing
You approve the diagnosis and quote before any work begins. No hidden fees and no surprise charges.
Satisfaction Commitment
Backed by the full HVAC resources of CanroHeat.ca and four decades of service in Greater Vancouver since 1985.
Relay / Switching Board Replacement Across Metro Vancouver
Same-day boiler parts installation throughout Greater Vancouver and the Fraser Valley.
Frequently Asked Questions
Need a Relay / Switching Board Replaced?
Genuine OEM parts, professionally installed and tested. Same-day service across Greater Vancouver.
A Division of CanroHeat.ca · Licensed Gas Fitters · Serving Greater Vancouver since 1985