Can you fix boiler flame keeps going out in Surrey?

Yes. BoilerPart.ca provides licensed, same-day diagnosis and repair for boiler flame keeps going out throughout Surrey and the surrounding Greater Vancouver, including Guildford, Fleetwood, Cloverdale, South Surrey. ca cleans or replaces the sensor and fixes the cause across Greater Vancouver.

Why does my boiler flame keep going out?

Usually a dirty or failed flame sensor (or poor ground) so the control can’t prove flame and shuts off. We clean or replace the sensor and check combustion.

The safety shut-off is working as designed; the cause should be repaired by a licensed technician.

Surrey, Greater Vancouver

Ignition & Flame

Boiler Flame Keeps Going Out in Surrey

Same-day, licensed boiler help across Surrey. Genuine OEM parts professionally installed — never sold for DIY. Trusted since 1985.

Call (604) 359-1081

Quick Answer

A boiler that lights then drops out seconds later usually has a dirty or failed flame sensor, a poor ground, or a gas/combustion fault — so the control can’t prove flame and shuts off. BoilerPart.ca cleans or replaces the sensor and fixes the cause across Greater Vancouver.

Boiler Flame Keeps Going Out help for Surrey homes

If the burner lights but the boiler shuts down within seconds and locks out, the flame-sensing circuit can’t confirm the flame — a classic flame-sensor symptom.

Our licensed technicians cover every Surrey neighbourhood — including Guildford, Fleetwood, Cloverdale, South Surrey, Newton, Whalley — with genuine OEM parts and a workmanship guarantee.

What you’re noticing

Fires then shuts off in seconds
Flame-loss / E012-type code
Repeated short ignition then lockout
Boiler “sees” no flame

Common causes

Dirty / oxidised flame sensor
Cracked sensor insulator
Poor ground connection
Gas pressure / combustion fault

What you can safely check first

Beyond these safe checks, do not open the boiler or touch gas, electrical or sealed components — BC law requires a licensed gas fitter. Call us for a proper diagnosis.

Note the error code and timing (lights then drops)

Confirm gas is on and pressure normal

Reset once only

Don’t open the boiler

When this is urgent in Surrey

Urgent if it leaves you with no heat in the cold.

Parts Are Professionally Installed — Not Sold for DIY

For your safety and to keep your manufacturer warranty valid, BoilerPart.ca does not sell loose boiler parts over the counter or for self-installation. Under BC regulations, gas appliance components must be installed by a licensed gas fitter. Every part we source is genuine OEM and is professionally fitted, tested, and certified by our Technical Safety BC–licensed technicians as part of a complete repair or installation.

Our Guarantees & Warranties

Every repair and installation is backed by genuine parts, licensed workmanship, and a promise to make it right.

Workmanship Guarantee

Every repair and installation is backed by our written workmanship guarantee. If a part we installed fails because of our work, we make it right.

Genuine OEM Parts

We fit only manufacturer-original (OEM) components so your boiler performs to spec and keeps its factory warranty intact.

Manufacturer Warranty Honoured

As an authorised service provider for the brands we work on, our installs preserve and register your manufacturer parts warranty.

Licensed & Insured

All work is completed by Technical Safety BC–licensed gas fitters. We are fully licensed, bonded and insured for your protection.

Up-Front Pricing

You approve the diagnosis and quote before any work begins. No hidden fees and no surprise charges.

Satisfaction Commitment

Backed by the full HVAC resources of CanroHeat.ca and four decades of service in Greater Vancouver since 1985.

Frequently Asked Questions